ZyXEL Communications Network Router NOT AVAILABLE Bedienungsanleitung PDF herunterladen (Seite 96)

Chapter 12 Dynamic Channel Selection

NXC CLI Reference Guide

12.2.1 DCS Examples

This example creates a DCS configuration.

dcs 5g-selected-channel 5g_channels Sets the channels that are available in the 5 GHz band

when you manually configure the channels an AP can

use.

dcs dcs-2g-method {auto|manual} Sets the AP to automatically search for available

channels or manually configures the channels the AP

uses in the 2.4 GHz band.

dcs dcs-5g-method {auto|manual} Sets the AP to automatically search for available

channels or manually configures the channels the AP

uses in the 5 GHz band.

dcs time-interval interval Sets the interval that specifies how often DCS should run.

dcs sensitivity-level {high| medium |low} Sets how sensitive DCS is to radio channel changes in

the vicinity of the AP running the scan.

dcs client-aware {enable|disable} When enabled, this ensures that an AP will not change

channels as long as a client is connected to it. If disabled,

the AP may change channels regardless of whether it has

clients connected to it or not.

dcs channel-deployment {3-channel|4-

channel}

Sets either a 3-channel deployment or a 4-channel

deployment.

In a 3-channel deployment, the AP running the scan

alternates between the following channels: 1, 6, and 11.

In a 4-channel deployment, the AP running the scan

alternates between the following channels: 1, 4, 7, and 11

(FCC) or 1, 5, 9, and 13 (ETSI).

Sets the option that is applicable to your region. (Channel

deployment may be regulated differently between

countries and locales.)

dcs dfs-aware {enable|disable} Enables this to allow an AP to avoid phase DFS channels

below the 5 GHz spectrum.

show dcs config Displays the current DCS configuration.

Table 45 Command Summary: DCS (continued)

COMMAND DESCRIPTION

Router(config)# dcs time-interval 720

Router(config)# dcs sensitivity-level high

Router(config)# dcs client-aware enable

Router(config)# dcs channel-deployment 3-channel

Router(config)# dcs dfs-aware enable

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 299 300

Keine Kommentare

ZyXEL Communications Network Router NOT AVAILABLE Bedienungsanleitung Seite 96