ZyXEL P-971M Bedienungsanleitung PDF herunterladen (Seite 81)

P-660H/HW/W-T Series User’ Guide

Appendix B 80

1 Assuming that you have only one network card on the computer, locate the ifconfig-

eth0

configuration file (where eth0 is the name of the Ethernet card). Open the

configuration file with any plain text editor.

• If you have a dynamic IP address, enter dhcp in the BOOTPROTO= field. The

following figure shows an example.

Figure 48 Red Hat 9.0: Dynamic IP Address Setting in ifconfig-eth0

DEVICE=eth0

ONBOOT=yes

BOOTPROTO=dhcp

USERCTL=no

PEERDNS=yes

TYPE=Ethernet

• If you have a static IP address, enter static in the BOOTPROTO= field. Type

IPADDR= followed by the IP address (in dotted decimal notation) and type

NETMASK= followed by the subnet mask. The following example shows an example

where the static IP address is 192.168.1.10 and the subnet mask is 255.255.255.0.

Figure 49 Red Hat 9.0: Static IP Address Setting in ifconfig-eth0

DEVICE=eth0

ONBOOT=yes

BOOTPROTO=static

IPADDR=192.168.1.10

NETMASK=255.255.255.0

USERCTL=no

PEERDNS=yes

TYPE=Ethernet

2 If you know your DNS server IP address(es), enter the DNS server information in the

resolv.conf file in the /etc directory. The following figure shows an example where

two DNS server IP addresses are specified.

Figure 50 Red Hat 9.0: DNS Settings in resolv.conf

nameserver 172.23.5.1

nameserver 172.23.5.2

3 After you edit and save the configuration files, you must restart the network card. Enter

./network restart in the /etc/rc.d/init.d directory. The following figure

shows an example.

1 2 ... 76 77 78 79 80 81 82 83 84 85 86

Keine Kommentare

ZyXEL P-971M Bedienungsanleitung Seite 81