ZyXEL 802.11g Bedienungsanleitung PDF herunterladen (Seite 116)

P-662H/HW-D Series User’s Guide

116 Chapter 6 LAN Setup

Figure 56 Advanced LAN Setup

The following table describes the labels in this screen.

Table 31 Advanced LAN Setup

LABEL DESCRIPTION

RIP & Multicast

Setup

RIP Direction Select the RIP direction from None, Both, In Only and Out Only.

RIP Version Select the RIP version from RIP-1, RIP-2B and RIP-2M.

Multicast IGMP (Internet Group Multicast Protocol) is a network-layer protocol used to

establish membership in a multicast group. The ZyXEL Device supports both IGMP

version 1 (IGMP-v1) and IGMP-v2. Select None to disable it.

Any IP Setup Select the Active check box to enable the Any IP feature. This allows a computer to

access the Internet without changing the network settings (such as IP address and

subnet mask) of the computer, even when the IP addresses of the computer and

the ZyXEL Device are not in the same subnet.

When you disable the Any IP feature, only computers with dynamic IP addresses or

static IP addresses in the same subnet as the ZyXEL Device’s LAN IP address can

connect to the ZyXEL Device or access the Internet through the ZyXEL Device.

Windows

Networking

(NetBIOS over

TCP/IP)

NetBIOS (Network Basic Input/Output System) are TCP or UDP packets that

enable a computer to connect to and communicate with a LAN. For some dial-up

services such as PPPoE or PPTP, NetBIOS packets cause unwanted calls.

However it may sometimes be necessary to allow NetBIOS packets to pass through

to the WAN in order to find a computer on the WAN.

Allow between

LAN and WAN

Select this check box to forward NetBIOS packets from the LAN to the WAN and

from the WAN to the LAN. If your firewall is enabled with the default policy set to

block WAN to LAN traffic, you also need to enable the default WAN to LAN firewall

rule that forwards NetBIOS traffic.

Clear this check box to block all NetBIOS packets going from the LAN to the WAN

and from the WAN to the LAN.

Back Click Back to return to the previous screen.

Apply Click Apply to save the changes.

Cancel Click Cancel to begin configuring this screen afresh.

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 495 496

Keine Kommentare

ZyXEL 802.11g Bedienungsanleitung Seite 116