ZyXEL 802.11g Bedienungsanleitung PDF herunterladen (Seite 94)

P-662H/HW-D Series User’s Guide

94 Chapter 5 WAN Setup

5.6 Configuring More Connections

This section describes the protocol-independent parameters for a remote network. They are

required for placing calls to a remote gateway and the network behind it across a WAN

connection. When you use the WAN > Internet Connection screen to set up Internet access,

you are configuring the first WAN connection.

Click Network > WAN > More Connections to display the screen as shown next.

cell/sec Divide the DSL line rate (bps) by 424 (the size of an ATM cell) to find the Peak Cell

Rate (PCR). This is the maximum rate at which the sender can send cells. Type the

PCR here.

Sustain Cell Rate The Sustain Cell Rate (SCR) sets the average cell rate (long-term) that can be

transmitted. Type the SCR, which must be less than the PCR. Note that system

default is 0 cells/sec.

Maximum Burst

Size

Maximum Burst Size (MBS) refers to the maximum number of cells that can be sent

at the peak rate. Type the MBS, which is less than 65535.

Zero

Configuration

This feature is not applicable/available when you configure the ZyXEL Device to

use a static WAN IP address or in bridge mode.

Select Yes to set the ZyXEL Device to automatically detect the Internet connection

settings (such as the VCI/VPI numbers and the encapsulation method) from the ISP

and make the necessary configuration changes.

Select No to disable this feature. You must manually configure the ZyXEL Device

for Internet access.

PPPoE

Passthrough

(PPPoE

encapsulation

only)

This field is available when you select PPPoE encapsulation.

In addition to the ZyXEL Device's built-in PPPoE client, you can enable PPPoE

pass through to allow up to ten hosts on the LAN to use PPPoE client software on

their computers to connect to the ISP via the ZyXEL Device. Each host can have a

separate account and a public WAN IP address.

PPPoE pass through is an alternative to NAT for application where NAT is not

appropriate.

Disable PPPoE pass through if you do not need to allow hosts on the LAN to use

PPPoE client software on their computers to connect to the ISP.

Back Click Back to return to the previous screen.

Apply Click Apply to save the changes.

Cancel Click Cancel to begin configuring this screen afresh.

Table 23 Advanced Internet Connection

LABEL DESCRIPTION

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 495 496

Kommentare zu diesen Handbüchern

Keine Kommentare

ZyXEL 802.11g Bedienungsanleitung Seite 94

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung ZyXEL 802.11g