ZyXEL 802.11g Bedienungsanleitung PDF herunterladen (Seite 97)

P-662H/HW-D Series User’s Guide

Chapter 5 WAN Setup 97

Multiplexing Select the method of multiplexing used by your ISP from the drop-down list.

Choices are VC or LLC.

By prior agreement, a protocol is assigned a specific virtual circuit, for example,

VC1 will carry IP. If you select VC, specify separate VPI and VCI numbers for

each protocol.

For LLC-based multiplexing or PPP encapsulation, one VC carries multiple

protocols with protocol identifying information being contained in each packet

header. In this case, only one set of VPI and VCI numbers need be specified for

all protocols.

VPI The valid range for the VPI is 0 to 255. Enter the VPI assigned to you.

VCI The valid range for the VCI is 32 to 65535 (0 to 31 is reserved for local

management of ATM traffic). Enter the VCI assigned to you.

IP Address This option is available if you select Routing in the Mode field.

A static IP address is a fixed IP that your ISP gives you. A dynamic IP address is

not fixed; the ISP assigns you a different one each time you connect to the

Internet.

If you use the encapsulation type except RFC 1483, select Obtain an IP

Address Automatically when you have a dynamic IP address; otherwise select

Static IP Address and type your ISP assigned IP address in the IP Address

field below.

If you use RFC 1483, enter the IP address given by your ISP in the IP Address

field.

Subnet Mask Enter a subnet mask in dotted decimal notation.

Refer to the appendices to calculate a subnet mask If you are implementing

subnetting.

Gateway IP address Specify a gateway IP address (supplied by your ISP).

Connection

Nailed-Up

Connection

Select Nailed-Up Connection when you want your connection up all the time.

The ZyXEL Device will try to bring up the connection automatically if it is

disconnected.

Connect on Demand Select Connect on Demand when you don't want the connection up all the time

and specify an idle time-out in the Max Idle Timeout field.

Max Idle Timeout Specify an idle time-out in the Max Idle Timeout field when you select Connect

on Demand. The default setting is 0, which means the Internet session will not

timeout.

NAT SUA only is available only when you select Routing in the Mode field.

Select SUA Only if you have one public IP address and want to use NAT. Click

Edit to go to the Port Forwarding screen to edit a server mapping set.

Otherwise, select None to disable NAT.

Back Click Back to return to the previous screen.

Apply Click Apply to save the changes.

Cancel Click Cancel to begin configuring this screen afresh.

Advanced Setup Click this button to display the More Connections Advanced screen and edit

more details of your WAN setup.

Table 25 More Connections Edit (continued)

LABEL DESCRIPTION

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 495 496

Kommentare zu diesen Handbüchern

Keine Kommentare

ZyXEL 802.11g Bedienungsanleitung Seite 97

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung ZyXEL 802.11g